Uzupełnienie podręcznika Hitachi Rac24ch2

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

Thank you for the video it's a big help. I have a metabo and when I fire it makes a wierd air release sound and it sounds like something is bouncing around inside the gun. What could that be? Thanks again for the awesome video

I have a hitachi n5008ac that has a huge leak at the valve bushing when resting. I replaced ALL the o-rings in the gun, including the two that seal the cylinder guide to the gun body. When that didn't fix the leak, I swapped out plastic and metal parts from a new/identical n5008ac metabo I had to buy, but I couldn't get the leak to stop. I slid the cylinder plate into the gun body to see if it was warped, but it fit snuggly.

Would love a more in depth explantion of how the exhaust system on Hitachi works?

Hi Gil,

Awesome videos ! hey quick question, why would my hitachi framing nailer fire without the nose being depressed. Also what is the grease and o ring lube you use?

My piston/driver blade assembly was replaced, now you can hear it moving freely inside the cylinder if you turn the gun upside down and right side up. Feels weak and hollow to use and doesn’t drive the nail all the way. Is the replacement o-ring too small and not making a tight enough seal?

Thanks a million for this interesting video that I have watched twice because I am trying to

I wish someone would address removing/replacing the freaking headcap. It goes bad as well

can you please do a disassemble on a paslode impulse framer either the im90ci or the framemaster

What did you say to use to clean the gun with?

I just replaced all orings and gaskets on an nr83aa3. There's now air leaking from the trigger when its half depressed, I've rechecked the valve, the ball, rings and plastic valve. They all look fine. Any ideas? I also used white lithium grease to lube everything, think I read somewhere to use that.

Thanks ! My sweet Hitachi 83 NR ( I think } started blowing air through the exhaust vent constantly. Any ideas ?

Thanks for that< I have a question what will cause air to come through the tip? A lot of air!

How does the piston go back up...?

Please address the range of pressure required by nailers, what it means, and why when setting a compressor within that range, why won’t the nailer cycle.

and thank you for that! my nr83a2 hitachi framing nailer's drive piston won't retract. any clue what's the main culprit?

Good information Mister . Thx

What side do you attach the spring when putting back together

for anyone how needs the end cap rubber thing is on amazon Superior Parts SP 876-711 Aftermarket Head Cap for Hitachi NV45AB / NV5AB2 / NV45AB2(S) / NV45AE

.

Zostaw komentarz

#0